isaacsimpson2499 isaacsimpson2499
  • 19-04-2024
  • Engineering
contestada

In a face milling process, it is required to decrease the height
of a block from
100mm
to
96mm
. The part has
500mm
width and
300mm
depth. The tool diameter is
40mm
. The process planner wants to set

Respuesta :

Otras preguntas

Why is it extremely dangerous to eat the “destroying angel” mushroom?
Marisol is painting on a piece of canvas that has an area of 180 square inches. The length of the painting is 11/4 times the width. What are the dimensions?
a+5=-5a+5 how do I solve this?
A helicopter’s speed increases from 25 m/sec to 60 m/sec in 5 seconds. What is the acceleration of this helicopter?
what dynasty was started by ali kolon
What is 4/1 + 3/4 =  equal to?
Why do you think it was a long time before many people began to object to slavery?What do you think finally led some people to try to abolish slavery
How to solv using elimination: 9x-2y=-21 2x+3y=16
Marisol is painting on a piece of canvas that has an area of 180 square inches. The length of the painting is 11/4 times the width. What are the dimensions?
An object is thrown off a cliff with a horizontal speed of 10 m/sec. After 3 seconds the object hits the ground. Find the height of the cliff and the total hori